Which of the following symbol modes are used to input of graphics to General CAD system?

A).  Live and Rectangle mode

B).  Dimension and Alphanumeric mode

C).  Dimension and Alphanumeric mode

D).  All of the above

E).  None of the above

• In an alloy, zinc and copper are in the ratio 1 : 2. In the second alloy, the same elements are in the ratio 2 : 3. If these two alloys be mixed to form a new alloy in which two elements are in the ratio 5:8, the ratio of these two alloys in the new allow
• Direction: Read the following information carefully and answer the questions that follow: P, V, X, A, D, I, K and U set out for trip for different number of days such as 2, 8, 11, 5, 6, 4, 7 and 3, they go to the trip in the same order but the order of n
• X and Y are two alloys which are prepared by mixing zinc and aluminium in the ratio of 1 : 4 and 11 : 8 respectively. If equal quantities of alloys are melted to form a third alloy Z then what is the ratio of zinc and aluminium in alloy Z?
• Study the following information carefully to answer these questions.A vehicle starts from point P and run 10 km towards North. It takes a right turn and runs 15 km. Now it runs 6 km after taking a left turn. Finally, it takes a left turn, runs 15 km and s
• Three measuring rods are of length 120 cm, 100 cm and 150 cm. Find the least length of the fence that can be measure an exact number of times, using any of the rods. How many times each rod will be used to measure the length of the fence?